Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
85
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
How to Use the
Operator Panel
3 Adjust the stacker to fit the longest document.
For details, refer to "1.8 Setting Up the Stacker" (page 30).
4 In the scanner driver, configure the scan settings to detect
the paper size automatically.
For details, refer to the scanner driver's Help.
5 Scan the document with the image scanning application.
For details, refer to the image scanning application manual.
Scanning Documents Folded in Half
Sliding the feed mode switch to the left to switch the feed
mode to Manual/Single mode allows you to scan a document
folded in half (a document of up to A1 or A2 in width that is
folded in half) as it is.
1 Fold the document in half so that the sides to be scanned
are facing out.
Fold it firmly and smooth out any creases.
Otherwise, it may cause the document to skew while the
feeding is in progress.
Example 1: A2 size
Example 2: A1 size
ATTENTION
When a document folded in half is scanned, the document may be fed
skewed if the folded part is too thick.
To Next Page
Loading...
