Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
188
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
2 From the listing on the left, select [Device Setting 2]
[Paper Protection Sensitivity].
3 Select a paper protection detection method which you
want to change the sensitivity level for.
Feeding Accuracy: Select this to detect a document that is unusually
warped when a feeding error occurs.
This is available when you have selected
[Feeding Accuracy] or [Feeding Accuracy &
Noise] for the paper protection detection method.
Feeding Noise: Select this to detect paper jam noise.
This is available when you have selected [Feeding
Noise] or [Feeding Accuracy & Noise] for the paper
protection detection method.
4 Specify the sensitivity level.
Low: Decreases the sensitivity level to detect warped documents or
paper jam noise.
Normal: Monitors warped documents or paper jam noise with normal
sensitivity.
Keep this setting for normal use.
High: Increases the sensitivity level to detect warped documents or
paper jam noise.
HINT
To detect paper warp or paper jam noise faster and stop the
scan, select [High].
To decrease the frequency of paper jam detection if paper jams
occur frequently in the feeder, select [Low].
This setting can also be configured with the operator panel.
When the operator panel setting is prioritized, the operator
panel setting is prioritized over the Software Operation Panel
setting.
To Next Page
Loading...
