Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
203
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
3 Use the slider to specify the waiting time for the scanner
to enter power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
HINT
Selecting the [Power off after a certain period of time] check box
turns the power off automatically if the scanner is left on for a
certain period of time without being used.
You can select the timeout period for the scanner to be
automatically turned off by [1 Hour]/[2 Hours]/[4 Hours]/[8
Hours].
This setting can also be configured with the operator panel.
To Next Page
Loading...
