Fujitsu FI-7600 - Operator Panel

How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
57
How to Load
Documents
Scanner
Overview
The operator panel consists of an LCD, buttons and an LED indicator.
Names and Functions
■
fi-7600
The scanner carries an operator panel on each side. You can use whichever is convenient for you. The operator panel can be
fitted into the side of the scanner when it is not used.
3.1 Operator Panel
0
H
Q
X
6FDQ(QWHU
&KHFN
6WRS&OHDU
LED Indicator
Lights in orange when an error occurs.
Flashes when the ADF is open, when consumables reach the end of their life cycle, or
when the value specified for the cleaning cycle or the regular maintenance time is
reached.
LCD
Indicates the status of the scanner.
Switches off when the scanner enters power saving mode.
[Stop/Clear] Button
Stops the scan immediately.
Cancels the selected item and returns to the previous screen. Clears the displayed
error indication.
Resets the page counter when pressed down for three seconds or longer.
[Scan/Enter] Button (*1)
Launches the linked application software.
Confirms the selected item.
Pauses the scan (*2). Resumes the paused scan.
Ejects the document when a multifeed occurs.
[Power] Button
Turns the power on/off. Lights in green when the scanner is turned on.
[]/[] Button
Switches the number (No.00 to No.50/SOP) for the application
that is launched when the [Scan/Enter] button is pressed while
the [Ready] screen is displayed. Switches the selected item.
*1: For details about setup method for a scan using the [Scan/Enter] button, refer to
the scanner driver's Help or "Using a Button on the Scanner to Start Scanning"
(page 90).
*2: Pressing the [Scan/Enter] button when scanning a document with ScanSnap
Manager for fi Series cancels the scanning process, after the document is
scanned.
[Menu] Button
Configures various types of scanning operations.
Determines whether or not to memorize the pattern if pressed when a multifeed
occurs.
Determines whether to enable or disable paper protection if pressed when a scanning
operation is stopped due to paper protection.
Status Indicator (LED)
Allows you to check the scanner status while the operator
panel is fitted into the side.
Lights in orange when an error occurs.
Flashes when the ADF is open, when consumables reach the
end of their life cycle, or when the value specified for the
cleaning cycle or the regular maintenance time is reached.
When the operator panel is
fitted into the side of the
scanner