Fujitsu FI-7600 - Page 67

How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
67
How to Load
Documents
Scanner
Overview
■Checking the Information
1 Press the [Power] button on the operator panel.
The [Ready] screen is displayed on the LCD.
2 Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
3 Press the [] or [] button and select [Information], then
press the [Scan/Enter] button to confirm.
The [Information] screen is displayed on the LCD.
4 Press the [] or [] button to check the contents of the
information.
You can check the messages for replacing consumables/cleaning/
glass cleaning/regular maintenance.
When the message prompts replacing consumables/cleaning, the
corresponding counter that requires consumable replacement/
cleaning is highlighted. The counter will appear highlighted when:
 The page count after the consumable is replaced reaches 95% of
the value configured in "Replacement Cycle of Consumables [Life
Counter Alarm Setting]" (page 176) in the Software Operation
Panel. (For the brake roller/pick roller counters)
 The page count after the scanner is cleaned reaches 100% of the
value configured in "Scanner Cleaning Cycle [Cleaning Cycle]"
(page 176) in the Software Operation Panel. (For the cleaning
counter)
 The amount of remaining ink is below 33%. This is only displayed
when the imprinter is installed. (For the ink counter)
2 [Menu] Button
3 []/[] Button
[Scan/Enter] Button
4 []/[] Button
1 [Power] Button
Me
n
u
Scan/Enter
C
h
e
ck
Powe
Powe
r
Stop/Clear
Me
n
u
Scan/Enter
Che
ck
Power
Stop/Clear
[fi-7600]
[fi-7700/fi-7700S]
ATTENTION
[Information] can be selected only when there is a message for
replacing consumables/cleaning/glass cleaning/regular
maintenance.