Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
92
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
How to Use the
Operator Panel
Settings on the Scanner
1 Press the [] or [] button while the [Ready] screen is
displayed on the operator panel.
The [Function Selection] screen is displayed.
2 Press the [] or [] button and select a parameter, then
press the [Scan/Enter] button to confirm.
Configure the application you want to launch when you press the
[Scan/Enter] button while the [Ready] screen is displayed.
Parameters in the [Function Selection] screen, application numbers in
the indicator, and events configured on the computer correspond to
one another as follows:
As an example, the following indicator displays an application number
"F02". This number is displayed by selecting [No.02] in the [Function
Selection] screen and performs the [Send to 02] event configured on
the computer.
3 Press the [Scan/Enter] button.
The specified application is launched.
Me
n
u
Scan/Enter
Che
ck
Power
Stop/Clear
[fi-7600]
[Scan/Enter] Button
[]/[] Button
Me
n
u
Scan/Enter
C
h
e
ck
PowePowe
r
Stop/Clear
[fi-7700/fi-7700S]
[Scan/Enter] Button
[]/[] Button
Parameter in
the [Function
Selection]
screen
Application number
in the indicator
Event configured on
the computer
No.00 F00 [Scan Button]
No.01 to No.50 F01 to F50 [Send to 01] to [Send
to 50]
SOP SOP N/A
To Next Page
Loading...
