Fujitsu M10 Product Notes

Table 3-17
Problems resolved in XCP 2070 (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
131108-001
xx xIf the "SCF Diagnosis initialize RTC"
error occurs, or if the motherboard unit
(MBU) is replaced with the SPARC
M10-1 and the CPU memory unit lower
(CMUL) is replaced with the SPARC
M10-4/M10-4S, the following phenomena
may occur.
[Phenomenon 1]
The XSCF time may return to January 1,
2001.
[Phenomenon 2]
The time
difference between the XSCF
and all physical partitions (PPARs) may
become a value of 400 million seconds or
more. You can check this phenomenon
by executing the showdateoffset(8)
command, since the time difference
between the XSCF and all PPARs is
displayed as a value of "400000000 sec" or
more.
XSCF>
showdateoffset
-a
PPAR-ID Domain Date Offset
00 400000100 sec
01 400000100 sec
:
:
15 400000100 sec
[Phenomenon 3]
If you reset the PPAR or power off and
on the PPAR, the Oracle Solaris time may
return to January 1, 2001.
There is no effective workaround.
Update to firmware version XCP 2221 or
later.
[How to restore]
For
details, see "Restoration after the
"SCF Diagnosis initialize RTC" error
(RTIF2-131108-001)."
RTIF2-
131112-010
xx x If you execute the XSCF commands in the
following order, the setting information
for the setntp(8) or settelnet(8) command
is not applied and may return to the
original state.
1. Execute any of the sethostname(8),
setnameserver(8), setnetwork(8),
setroute(8), or setsscp(8) command.
2. Execute either the setntp(8) or
settelnet(8) command.
3. Execute the applynetwork(8) command.
After executing any of the sethostname
(8), setnameserver(8), setnetwork(8),
setroute(8), or setsscp(8) command is
executed, do not execute the setntp(8) or
settelnet(8) command until the
applynetwork(8) command is executed
and the settings are applied.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 2015136

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English