Fujitsu MCE3064SS - Page 16

C156-E097-01EN xv
FIGURES
page
1.1 MCE3064SS/MCF3064SS outer view (with panel).............................................................1 - 6
1.2 MCE3064SS/MCF3064SS outer view (without panel) .......................................................1 - 6
1.3 Optical disk drive configuration...........................................................................................1 - 7
1.4 Control circuit section block diagram ..................................................................................1 - 8
1.5 System configuration example ............................................................................................1 - 10
2.1 Optical disk cartridge............................................................................................................2 - 16
2.2 Algorithms for alternate processing ....................................................................................2 - 20
2.3 Example of alternate processing...........................................................................................2 - 21
3.1 Surface temperature measurement points.............................................................................3 - 2
3.2 Dimensions ...........................................................................................................................3 - 5
3.3 Dimensions (without panel)..................................................................................................3 - 6
3.4 Installation directions ...........................................................................................................3 - 7
3.5 Centers of gravity..................................................................................................................3 - 8
3.6 Mounting frame structure .....................................................................................................3 - 9
3.7 Service clearance ..................................................................................................................3 - 10
3.8 Current waveform (+5 VDC)................................................................................................3 - 11
3.9 Power on/off sequence (1)....................................................................................................3 - 11
3.10 Power on/off sequence (2)....................................................................................................3 - 12
3.11 Power on/off sequence (3)....................................................................................................3 - 12
3.12 AC noise filter (recommended)............................................................................................3 - 13
3.13 Connector and terminal locations.........................................................................................3 - 14
3.14 Power supply connector........................................................................................................3 - 15
3.15 SCSI interface connector (drive side)...................................................................................3 - 15
3.16 Cable connection mode.........................................................................................................3 - 17
3.17 SCSI cable connector............................................................................................................3 - 19
3.18 SCSI cable connection..........................................................................................................3 - 21
3.19 External operator panel circuit example...............................................................................3 - 23
3.20 External operator panel interface connector.........................................................................3 - 24
4.1 Packaging style .....................................................................................................................4 - 3
4.2 SCSI bus connection modes ................................................................................................4 - 4
4.3 Positions of setting terminals and switches..........................................................................4 - 6
4.4 Setting switch (SW1)............................................................................................................4 - 7