RX200 S4 Operating manual 101
CSS components Hot-plug components
Figure 30: Removing the fan
Ê Take hold of the fan by the green touch points (1) and lift it out of the housing.
Ê Set the fan down on the outside of the server.
V CAUTION!
Never set a removed/defective fan down inside the server. Risk of
short circuit!
Mounting is performed in the reverse order.
I The new fans are measured with explicit commands in Server
Management. Depending on the result, the corresponding LED is set to
orange (fan is not in order).
Ê Return the fan cover to its position (see section “Opening/closing the fan
cover” on page 99).
1
1
To Next Page
Loading...
