RX200 S4 Operating manual 67
Startup and operation Switching the server on and off
5.2 Switching the server on and off
V CAUTION!
If nothing appears on the screen but flickering stripes after switching on
the server, switch the server off immediately (see section “Flickering
stripes on monitor screen” on page 79).
The On/Off button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plug(s).
Switching the server on
The power-on indicator (item 10 in figure 12 on page 57) lights orange.
– Starting up for the first time:
Ê Press the On/Off button (item 5 in figure 12 on page 57).
Power-on indicator (item 6 in figure 12 on page 57) lights green.
Ê Insert ServerStart DVD in the DVD drive.
Ê Follow the on-screen instructions (see also section “Configuration with
ServerStart” on page 71 or section “Configuration without ServerStart”
on page 72).
– System already installed:
Ê Press the On/Off button (item 5 in figure 12 on page 57).
Power-on indicator (item 6 in figure 12 on page 57) lights green.
The server is switched on, performs a system test and boots the
operating system.
To Next Page
Loading...
