Fujitsu Primergy RX200 S4 - Replacing an Expansion Card; Removing the Riser Module

RX200 S4 Operating manual 107
CSS components Replacement of non-hot-plug components
8.2.3 Replacing an expansion card
8.2.3.1 Removing the riser module
Figure 37: Removing the riser module
Ê If necessary, remove the cables from the defective expansion card.
Ê Hold the riser module at the green dots (a) marked "LIFT UP" and carefully
pull the riser module up and out (1).
a
1
a
a