RX200 S4 Operating manual 69
Startup and operation Configuring the server
5.3 Configuring the server
This section contains information about configuring the server and installing the
operating system.
I Make sure that the power saving functions are disabled in the Power
menu of the BIOS Setup during operation.
5.3.1 Configuring the onboard SATA controller
A SATA controller is integrated on the system board. You can configure the
onboard SATA controller either before or during ServerStart. Using ServerStart
is recommended.
I The controller has its own configuration utility. More detailed information
may be found in the "LSI SATA Software RAID User’s Guide" (on the
ServerBooks DVD under "Controllers").
I Descriptions of operating systems not covered in the RAID controller
manual are provided in the appropriate readme files on the driver CDs.
5.3.2 Configuring the PCI SAS controller with
“Integrated Mirroring Enhanced”
The server has an PCI SAS controller with “Integrated Mirroring Enhanced”
functionality. You can configure the PCI SAS controller either before or during
ServerStart. Using ServerStart is recommended.
I A separate utility is available to the controller for IME configuration.
Further information can be found in the “Integrated RAID for SAS User’s
Guide” (on the ServerBooks DVD under “Controllers”).
I Descriptions of operating systems not covered in the RAID controller
manual are provided in the appropriate readme files on the driver CDs.
To Next Page
Loading...
