66 Operating Manual RX200 S5
Switching the server on and off Starting up and operation
Switching the server off
Power-on indicator (item 10 in figure 12 on page 55) lights green.
Ê Shut down the operating system properly.
The server is automatically switched off. The power-on indicator lights up
orange.
I If the operating system does not switch the server off automatically,
press the On/Off button for at least four seconds and/or send a
corresponding control signal.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
– Specified switch on time / switch off time
The server is switched ON or OFF at a time specified in the ServerView
Operations Manager.
– Ring indicator
The server is switched on by an internal or external modem.
– Wake On LAN (WOL)
The server is switched on by a command via the LAN (Magic Package).
– After power failure
The server automatically reboots following a power failure (depending of the
settings in the BIOS).
– Power button override
The system can be switched off (hard power off) by holding down the On/Off
button (approximately 4 - 5 seconds).
V CAUTION!
There is a risk that data may be lost.
– iRMC S2
iRMC S2 offers various options for switching the server on and off, e.g. via
the Power On Off page of the iRMC S2 Web interface.
To Next Page
Loading...
