88 Operating Manual RX200 S5
Hot-plug components CSS components
Figure 22: Installing the 2.5-inch HDD module
Ê Carefully push the HDD module into the empty slot (1) until it stops.
Ê Push the handle completely (2) until the locking mechanism engages.
8.1.2.5 Removing the HDD module
V CAUTION!
● Only remove a HDD module during operation if the drive is not
currently being accessed. Observe the control LEDs for the
corresponding HDD modules (see "Hard disk drive indicators" on
page 59).
● Under no circumstances should you remove a HDD module while the
system is in operation if you are not sure that the hard disk drive is
operated by a RAID controller and belongs to a disk array that is
operating in RAID level 1, 10, 5 or 6.
A HDD module can only be replaced during operation in conjunction
with a corresponding RAID configuration.
● All HDD modules (drives) must be uniquely identified so that they can
be reinstalled in their original mounting locations later. If this is not
done, existing data can be lost.
If you want to remove a HDD module during operation, proceed as follows:
1
2
To Next Page
Loading...
