RX200 S6 Options Guide 65
Expansion cards and iBBU
Connecting iBBU cable to modular RAID controller in riser card #3
Figure 36: Routing the iBBU cable to modular RAID controller in riser card #3
Ê Route the iBBU cable as shown.
I The iBBU cable must pass beneath the power cable that crosses the
iBBU cable.
Ê Connect the free connector of the iBBU cable to the corresponding
connector on the modular RAID controller (see circle).
I The connector is protected against polarity reversal, in other words,
the connector can only be connected one way round.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 73.
To Next Page
Loading...
