52 Operating Manual RX200 S6
Hardware installation
Ê Insert (3) the safety lock into the easy lock (snap fit).
V CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted!
Ê Repeat the above steps for the right-hand support system (with the front and
rear right support uprights).
Ê Fit the PRIMECENTER/DataCenter rack cable management as described in
the technical manual for the corresponding rack.
Preparing the server
Figure 6: Preparing the server
Ê Place the outer telescopic rails on the sides of the server (see arrow 1 in
figure 6).
Ê Slide the outer telescopic rails forwards to secure them (see arrow 2 in
figure 6).
1
2
To Next Page
Loading...
