First-time setup of your device
Switching on the device for the first time
Switchingonforthefirst time
When you switch on the d evice for the first time, the supplied software is
installed and configured. Because this procedure must not be interrupted,
you should set aside enough time for it to be fully completed and connect
the device to the mains using the m ains adapter.
During the installation process, DO NOT restart the device unless
you are requested to do so!
To make it easier to use yo
ur device for the first time, the operating system
is pre-installed on the
hard disk.
2
1
2
► Press the ON/OFF button (1) for about one second to switch the device on.
The power-on indicators (2) light up whenever the syste m is switched on.
► D uring installation, follow the instructions on screen.
18 Fujitsu
To Next Page
Loading...
Need help?
General