Actions (for Windows users)
145
Using the Quick Menu
1. Insert the business card straight into the feeding section of the
ScanSnap, with the scanning side facing up.
D Business card is pulled in until it is set inside the ScanSnap.
To use the Quick Menu, you need to select the [Use Quick Menu] check box in the ScanSnap
setup dialog box.
For details about how to perform scanning by using the Quick Menu, refer to "Using the Quick
Menu" (page 67).
z When [Business card] is specified for [Paper size] in the [Paper] tab of the ScanSnap
setup dialog box, insert the business card by aligning it with the left edge of the feeding
section.
z If you perform a scan with the output guide open, a
paper jam may occur and damage business cards.
Make sure to close the output guide when you scan
business cards.
To Next Page
Loading...
