246
8. Attach the new pick roller to the shaft.
Insert the shaft aligning the protrusion with the slot on the new pick roller.
9. Install the pick roller with it’s shaft to the scanner.
Insert the right end of the shaft to the roller bushing (right), and set the shaft to the slot while
lowering it.
ATTENTION
If you push up the pick roller tab using your fingernail, your fingernail may be
hurt or get chipped. If you cannot push it up successfully with your fingernail,
use a paper clip to push up the pick roller tab.
1
2
Shaft
Protrusion
Pick roller
Slot
Pick roller
Pick roller shaft
To Next Page
Loading...
