Working with the notebook
Setting up the port replicator
Select a suitable location for the Port Replicator before setting it up.
Follow the instructions below when doing so:
• Never place the port replicator on a soft surface (e.g. carpeting, upholstered furniture, bed).
This can block the air ve nts of the notebook and cause overheating and damage.
• Place the port replicator on a sta ble, flat and non-slip surface. Please note that the
port re plicator’s rubber feet may mark certain types of surface.
• Never place the port replicator and the m ains adapter on a hea t-sensitive surface.
• Do not expose the port replicator to extreme environmental conditions.
Protect the port replicator from dust, humidity and heat.
Connecting the mains adapter to the Port Replicator
3
1
2
► Connect the power cable (1) to the power
adapter provided for the device, see
chapter "
Technical data", P age 88.
► Plug the power cable into the mains
socket (2).
► Connect the mains adapter cable to the D C
jack (DC IN) of the Port Replicator (3).
When the notebook is connected to a Port Replicato r, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will b e loaded, as
soon as th e notebook is connected to a Port Replicator of the same typ e.
54 Fujitsu
To Next Page
Loading...
Need help?
General