EasyManuals Logo

Fujitsu U9310X User Manual

Fujitsu U9310X
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
Troubleshooting and tips
Error messages on the screen
Errormessages onthescr eenErrormessage:
This section describes the error m essages generated by the BIOS Setup. Error messag es displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measure s, please
contact the place of purchase or our customer service centre.
Error message/cause Resolution
CMOS ba ttery bad
If the error message occurs repeatedly, the
buffer battery in the no tebook is at.
Contact your sales outlet
or our customer
service centre.
System CMOS checksum bad - default conguration
used
The system conguration inform ation is
incorrect.
Switch the notebook of
f.
Switch the notebook on.
Press the function k
ey
F2
to access the
BIOS Setup.
In the BIOS Setup, select the Ex it menu.
Select the entry Lo
ad Setup Defaults.
Select OK and p ress the En ter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing th e extended mem ory an error has
resulted at the address xxxx.
Check whether the add itional memory
module has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive are incorre ct.
Start the BIOS Setup (Pri m ary Master
submenu) and select the correct settings.
Keyboard controller error
Switch the notebook off using with the
ON/OFF button.
Wait 3 - 5 seconds and switch on the
notebook aga in.
Keyboard error
If you are using an external keyboard:
Check the connection and reboot the
notebook.
nn Stuck key
Make sure that no key is pressed.
Operating system not found
Check
in the BIOS Setup whether your hard
disk h
as been set correctly.
Make sure that the operating system is
installed on the corresponding drive.
Press <F1> to resume, <F2> to SETUP
This error message appears if an error occurs
during the self-test before starting the operating
system.
Press the
F1
function key to start the
operating system.
Press the function key
F2
to access the
BIOS Setup.
86 Fujitsu

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu U9310X and is the answer not in the manual?

Fujitsu U9310X Specifications

General IconGeneral
BrandFujitsu
ModelU9310X
CategoryLaptop
LanguageEnglish

Related product manuals