3. ARP OPERATION
3-10
Other ARP symbols
Item Symbol Status Remarks
Trial maneuver T
(flashing)
Bottom center
Appears during execution of a trial
maneuver.
Performance
test
XX
(flashing)
Bottom center Appears during performance test.
3.7.2 Choosing ARP symbol (B, C and W types)
In addition to the “standard” circle ARP symbol you may choose from the
symbols shown below.
1. Place the cursor on the ARP symbol you want to change.
2. Press the [TARGET DATA] key on the keyboard or display TARGET DATA &
ACQ in the guidance box and push the wheel.
3. Press the [TARGET DATA] key on the keyboard or the wheel consecutively
until desired symbol is displayed.
3.7.3 ARP symbol brilliance
1. Roll the trackball to choose the BRILL box at the left side of the screen and
then push the right button.
2. Roll the wheel to choose 0 NEXT and then push the wheel or the left button.
[BRILL1 MENU (2/2)]
1 BACK
2 BRG CURSOR
3 EBL
4 VRM
5 INDEX LINE
6 ARP SYMBOL
7 AIS SYMBOL
8 L/L GRID
9 MARK
0 CHART
BRILL menu, page 2
3. Roll the wheel to choose 6 ARP SYMBOL and then push the wheel or the left
button.
4. Roll the wheel to adjust brilliance.
5. Push the right button twice to close the menu.
To Next Page
Loading...
