5. VIDEO PLOTTER OPERATION
5-23
[WPT SET]
1 BACK
2 WPT NO. SELECT
000
3 WPT NAME
4 WPT L/L
00°00.000 N
000°00.000 E
5 CLEAR DATA
5.12.2 Editing, erasing waypoints from the menu
You may edit or erase waypoints from the menu as follows:
1. Roll the trackball to choose the MENU box at the right side of the screen and
then push the left button.
2. Roll the wheel to choose 8 [NAV LINE•WPT] and then push the wheel or the
left button.
3. Roll the wheel to choose 6 [WPT SET] and then push the wheel or the left
button.
WPT SET menu
4. Roll the wheel to choose 2 WPT NO. SELECT and then push the wheel or
the left button.
5. Use the wheel to enter waypoint number you wish to edit and then push the
wheel or the left button. Then, do one of the following:
• To change the waypoint name, roll the wheel to choose 3 WPT NAME and
then push the wheel or the left button. Use the wheel to edit waypoint
name.
• To edit the waypoint position, roll the wheel to choose 4 WPT L/L and then
push the wheel or the left button. Use the wheel to edit waypoint position.
• To erase the waypoint, roll the wheel to choose 5 CLEAR DATA and then
push the wheel or the left button. Note that a waypoint cannot be erased if
it is part of a nav line.
6. Push the right button three times to close the menu.
To Next Page
Loading...
Need help?
General
