Indicates a condition that can cause death or serious injury
if not avoided.
The operator and installer must read the applicable safety instructions before attempting to
operate or install the equipment.
WARNING
CAUTION
Indicates a condition that can cause minor or moderate
injury if not avoided.
Warning, Caution Prohibitive Action
Mandatory Action
WARNING CAUTION
ELECTRICAL SHOCK HAZARD
Do not open the equipment.
Hazardous voltage exists inside the
equipment. Refer repair to authorized
service personnel.
Do not disassemble or modify the
equipment.
Fire, electrical shock or injury can result.
Immediately turn off the power at the
switchboard if the equipment is
emitting smoke or fire.
Continued use of the equipment can
cause fire or electrical shock. Contact a
FURUNO agent for service.
Do not maneuver the vessel based on
the depth indication alone.
Grounding can result
Use the proper fuse.
Use of an incorrect fuse can damage the
equipment and can cause fire.
Do not turn on the equipment with the
transducer out of water.
The transducer can be damaged.
The picture is not refreshed when the
picture advance setting is ’’Off’’.
Maneuvering the vessel in this condition
can result in a dangerous situation.
Adjust the gain correctly.
If the value of the gain setting is too
small, weak signals will be suppressed
and no indication appears. If the value is
too large, noise will fill the screen and the
indication will be difficult to distinguish. It
is dangerous to use the depth display as
a reference when operating the vessel
without a clear indication of the seabed.
The LCD panel is made of glass.
Handle it with care.
Injury can result if the glass breaks.
Do not use high-pressure cleaners to
clean this equipment.
This equipment has the waterproof rating
outlined in the specifications, at the back
of this manual. However, the use of
high-pressure cleaning equipment can
cause water ingress, resulting in damage
to, or failure of, the equipment.
To Next Page
Loading...
