Navigation Sensors •
••
• 311
Press Stop button when you
have defined alignment.
5. Press Stop button in Position sheet. The alarm "2061 Chart Align: Executing" disappears
automatically and the amount of alignment is transferred to the ECDIS and range and bearing
of it is display in this field. If you want to cancel the alignment process then press Cancel
button and the process is terminated without any new alignment.
6. If the position source is Dead Reckoning, then the system sets a new start position to the Dead
Reckoning. In this case there is no offset and no indication text OFFSET. If the position
source is something else than Dead Reckoning, then the indication of OFFSET is displayed on
Upper information area. See Figure below.
Upper information area on ECDIS screen.
To Next Page
Loading...
