Furuno TZT14 - How to Backup the Equipment Settings; How to Load the Equipment Settings

8. FILE OPERATIONS
8-5
8.7 How to Backup the Equipment Settings
You can save the settings to an SD card to use the settings on other TZT units.
1. Put a blank formatted SD card in the right card drive.
2. Select [Menu] on the menu icon bar to open the main menu.
3. Select [Files].
4. Select [BackUp Settings].
5. Select [SD-Right].
6. After the equipment has exported the settings, select [Close] to exit the menu.
8.8 How to Load the Equipment Settings
You can load the saved settings in an SD card to this unit.
1. Put the correct SD card in either card drive.
2. Select [Menu] on the menu icon bar to open the main menu.
3. Select [Files].
4. Select [Restore Settings].
5. Select [SD-Right] or [SD-Left].
6. Select the settings to load then select [OK].
7. After the equipment has loaded the settings, select [Close] to exit the menu.
Cancel
SD-RightSD-Left
Backup Settings
Restore Settings
SD-Right
OK Cancel
SD-Left
AAAAAAA