Furuno TZT14 - How to Find a Point; How to Show or Hide All Points or Points Names; How to Go to a Point

4. POINTS
4-10
4.8 How to Find a Point
You can easily move a point to the center of the screen from the points list.
1. Select [Lists] on the menu icon bar to open the lists menu.
2. Select [Points List] to open the points list.
3. Select [Name], [Color], [Icon] or [Range] in the [Sort by] area at the top of the list.
4. Select the point to find then select [Find On Chart].
The menu closes and the selected point is put at the center of the screen on the
active chart plotter display.
Note: When you use this function in the split-screen display, the split-screen dis-
play is replaced with the full-screen display.
4.9 How to Show or Hide All Points or Points Names
Points
You can show or hide all points.
1. Select [Overlay] from the RotoKey menu.
2. To show all points, select [Points]. To hide all points, deselect [Points].
Points Names
You can show or hide all points names.
1. Select [Menu] on the menu icon bar to open the main menu.
2. Select [Points].
3. To show all points names, select the [ON] icon in [Display Points Names]. To hide
all points names, select the [OFF] icon.
4.10 How to Go to a Point
Select the point to go to among the three methods shown below.
• Select the point on the screen
• Select a position on the screen
• Select the point from the points list
After you have selected a point, you can do the following.
• Restart the cross-track error (XTE) indication.
• Stop and restart Go To. (Select the boat icon to display the pop-up menu. Select
[Stop Nav.] and [Restart Nav.] respectively.)
Note: Before you try to go to a point, make sure that the path to the point is clear. Make
sure to zoom your chart to check for hazards which appear on a smaller scale.