Furuno TZT14 - Page 98

4. POINTS
4-9
5. To change the name of the point, select [Name] to display the software keyboard.
Change the name as follows:
1) Select the character to edit. For example, "1" is selected in the following figure.
2) Select an alphanumeric character from the software keyboard.
3) Repeat steps 1) and 2) to complete the name. A name can have a maximum
of 20 alphanumeric characters.
4) Select [Confirm].
6. To change the position, select [Position] to display the software keyboard. Set the
position referring to step 5.
7. Select [Color] to change the color of the point symbol.
8. Select a color.
9. Select [Icon] to change the point symbol.
10. Select a symbol.
11. Select [Comment] to display the software keyboard.
12. Enter the comment for the point.
13. Select [Confirm].
14. Select [Save].
15. Select [Close] to exit the menu.
Select this to switch to the
numeric software keyboard.
Select this to switch to the
alphabet software keyboard.
Numeric software keyboard
Alphabet software keyboard
: Delete the character selected.
: Clear all characters.
Cursor
Cancel
Confirm
Cancel
Confirm
Del.
Clr.
Select position format.
“N” and “S” appear when the cursor is on
“N”. When you select “W”, “N” and “S” are
replaced with “E” and “W”.
Confirm
Cancel
Clr
•
123
456
789
0
3
N
Clr
•
123
456
789
0
Confirm
Cancel