Gaggia Anima - Default Chapter; Table of Contents

GAGGIA ANIMA
Table of contents Page
6. Standard checks
6.1. Repair schedule 1
6.2. Service schedule 1
6.3. Final test 2
7. Disassembly
7.1. Outer Shell
1
7.2.
Dispenser
2
7.3. Co ee grinder
3
7.4. Grinder blades
3
7.5. Co ee grinder adjustment
4
7.6.
Carafe connection and hot/Steam water dispenser
5
7.7.
Central plate
5
7.8. Pin boiler
6
7.9. Gear motor
6
7.10. Pump
7
7.11. Flow-meter
7
7.12.
Boiler
7
7.13. CPU board
8
7.14 Programming access for SSC (Saeco Service Center)
8
7.15. KYB interface and display
8
7.15. Fitting and removing Oetiker clamps
9
8. Notes
9. Water circuit diagram
10 Electrical diagram
Table of contents Page
1. Introduction
1.1. Documentation required 1
1.2. Tools and equipment required 1
1.3. Material 1
1.4. Safety warnings 1
1.5 Service Policy 2
1.6.1. External machine parts Anima XL
1.6.2. External machine parts Anima OTC 3
1.6.3. External machine parts Anima AMF - CMF 4
1.6.4. Internal machine parts 5
2. Technical speci cations
2.1. Technical speci cations 1
2.2.1. Speci cation for the measurement of the co ee products
temperature
2
2.2.2. Speci cation for the measurement of the milk products
temperature
3
2.3. Machine parameters and performance 5
3. User instructions
3.1. Customer menu 1
3.2. Operation, cleaning and maintenance 3
4. Operating logic
4.1. Water circuit 1
4.2. Milk carafe 2
4.3. Single microswitch 3
4.4. Temperature sensor 3
4.5. Co ee grinder 4
4.6.
Detection of co ee bean absence, dose adjustment,
blocked co ee grinder.
4
4.7.
Dose self-learning (SAS) only for 120v 5
4.8. Co ee grinder 6
4.9. Autodose sistem description 6
4.10. Co ee lack detection and co ee grinder blocked. 7
4.11. Co ee cycle 8
4.12. Water level detection (water tank) 9
4.14. Descaling request 9
4.14. Water  lter 10
5. Troubleshooting
5.1. Test mode Incanto
1
5.1.1. SteamOut 7
5.2. Error Codes 9