Gallagher SmartScale 800 - The mode select switch

3E1151SmartScale800UserManual

 9

Themodeselectswitch
TheScalecanoperateinthreeweighingmodesandasetupmode.
ThemodeselectswitchislocatedonthelefthandsideoftheScale.

Themodeselectswitchhasfivepositions: ,A,M,FandS.Immediatelyafter
youturntheswitchtoanypositionexcept ,explanatoryinformationwill
displayonthelowerofthetwoScalescreens.Theexplanatoryinformationwill
displayonlyforafewseconds;afteritdisappears,thescreendisplays
informationrelevanttotheselectedoption.

ThispositionturnstheScaleoff.
A
ThispositionselectsweighinginAutomaticmode.
YoucanalsostoreElectronicIDsandupdatetheScale'scross‐
referencetablewhentherearenoloadbarsconnected.
M
ThispositionselectsweighinginManualmode.
Youcanalsorecordanimalinformation,withoutweighing,when
therearenoloadbarsconnected.
F
ThispositionselectsweighinginFinemode.Itisdesignedforstatic‐
loadweighing.Static‐loadweighingcanoccurinstandardortrait
sessions..
S
Thispositionaccessesthesetupoptions.
