Gallagher SmartScale 800 - Installing the Loadbars; Installing the Scale

 3E1151SmartScale800UserManual

4

Installingtheloadbars
Toinstalltheloadbars,followthesesteps:
Note:Fittheloadbarsasperthemanufacturer'sinstructions.
1. Bolttheplatformtotheloadbars.
2. Ensuretheplatformisplacedonaflatandlevelsurface.Makesureitisnot
touchinganyrailsorgates.
3. Eitherbolttheloadbarstotheconcretepadorlocatethemonstudssetinto
theconcrete.Thiswillpreventtheplatformfrommovingduringthe
weighingsession.
4. ConnecttheloadbarcablestotheScale.
Note:IfyouareusingnonGallagher,loadbarsensuretheloadbarsarecorrectly
calibrated.
InstallingtheScale
TheScalecanbeplacedonatabletopormountedontheScalebracketsupplied.
PositiontheScale:
 clearoftheplatformtoensureitdoesnotinterferewiththeflowof
animalsduringtheweighingcycle
 withineasyreachoftheloadbarleads
 withineasyreachoftheoperator(formanualweighing),and
 inawell‐litarea