GAT ECO.Lock 7xxx F/ISO
Start-Up
www.gantner.com
HB_GAT-ECOLock-7xxxFISO--EN_12
27
4
START-UP
4.1 Power Supply
4.1.1 Battery Information
The GAT ECO.Lock 7xxx F/ISO is powered by three 1.5 V AA batteries (see “7. TECHNICAL DATA”). The
battery lifespan is designed around a defined number of locking cycles. The actual lifespan depends upon the
number of locking cycles (usage frequency of the lock) and the environmental conditions. All three batteries must be
replaced when the predefined number of locking cycles is reached or when the battery voltage becomes weak. If
the battery voltage becomes too weak, the locker can no longer be locked. The GAT ECO.Lock 7xxxx F/ISO
indicates a weak battery state with five red flashes of the LED ring and five acoustic signals during a locking
attempt.
NOTE! For optimal battery lifespan, use the approved battery available from GANTER (Batterie 1.5V Alkali
AA, Part No. 308819).
4.1.2 Inserting the Batteries
Before putting the GAT ECO.Lock 7xxx F/ISO into operation, the batteries must be inserted into the battery
compartment. In order to access the battery compartment, the battery cover on the back of the housing must
be removed, which is done using the supplied battery key.
NOTE! To avoid unnecessary battery usage, insert the batteries directly before the GAT ECO.Lock 7xxx
F/ISO is installed.
► Insert the battery cover key into the slot on the underside of the GAT ECO.Lock 7xxx F/ISO.
Figure 4.1 - GAT ECO.Lock 7xxx F/ISO battery compartment
To Next Page
Loading...
Need help?
General
