Viewing E-label Regulatory and Compliance Information
The label for this device is provided electronically. The e-label may provide regulatory information, such as
identification numbers provided by the FCC or regional compliance markings, as well as applicable product and
licensing information. Not available on all models.
1 Select Settings.
2 Select System.
3 Select Regulatory Information.
My Vessel Settings
NOTE: Some settings and options require additional charts or hardware.
Select Settings > My Vessel.
Keel Offset: Offsets the surface reading for the depth of a keel, making it possible to measure depth from the
bottom of the keel instead of from the transducer location (Setting the Keel Offset, page48).
Vessel Type: Enables some chartplotter features based on the boat type.
Fuel Capacity: Sets the combined fuel capacity of all the fuel tanks on your vessel (Setting the Fuel Capacity of
the Vessel, page87).
Fill Up All Tanks: Sets the tank levels to full (Synchronizing the Fuel Data with the Actual Vessel Fuel, page87).
Add Fuel to Boat: Allows you to enter the quantity of fuel you added to your tank, when you did not entirely fill up
the tank (Synchronizing the Fuel Data with the Actual Vessel Fuel, page87).
Set Total Fuel Onboard: Sets the combined amount of fuel in all the fuel tanks on your vessel (Synchronizing the
Fuel Data with the Actual Vessel Fuel, page87).
Set Gauge Limits: Sets the upper and lower limits of various gauges (Customizing Engine Gauge and Fuel Gauge
Limits, page99).
CZone™: Sets the digital switching circuits.
SeaStar Instance: Sets the digital switching circuits.
Hull ID: Allows you to enter the Hull Identification Number (HIN).The HIN might be permanently affixed to the
upper starboard side of the transom or outboard side.
Device Configuration 97
To Next Page
Loading...
Need help?
General
