Gate Titan User Guide

25
WWW.GATEE.EU
USER GUIDE
04
If all the three LED indicators are ON, this means an error.
05
06
A) SAFE - SEMI ~45°
B) SEMI - AUTO ~135°
A
B
SAFE AUTO
SEMI
This error occurs mostly when selector plate doesn’t reflect light (check p. 21). It can also
occur if too much light reaches sensors. Then you need to cover the sensors.
Turn the gear slowly to check if the sensor
detects teeth.
Keep in mind that the TITAN reads the
sensors much quicker than the programming
card.
Insert gearbox into body and check
whether the TITAN detects the fire
selector position correctly.
Switch should take place approximately
halfway between selector positions:
Otherwise, you need to modify the
selector plate with other sticker (p. 21).

Gate Titan Specifications

General

MOSFET	Yes
Battery protection	Yes
Trigger sensitivity adjustment	Yes
Pre-cocking	Yes
ROF control	Yes
Active brake	Yes
Diagnostic system	Yes
Programmable	Yes
Cycle Detection	Yes
Compatibility	V2 Gearbox
Low current consumption in sleep mode	0.2mA
Connectivity	USB-Link, Blu-Link
Fire Modes	Semi, Burst
Bluetooth support	Yes