53
WWW.GATEE.EU
USER GUIDE
6.3 Frequent problems
malfunction POSSIBLE REASON WHAT TO DO
• No connection with battery
• The selector is switched to SAFE
• Error during firmware update
• The motor is not connected
• Negative result of the built-in self-
test
• Read the DTC
• Clean the battery connector
• Clean the TITAN deans-t
connector
• Check if the wires are damaged
• Switch the selector to SEMI or
AUTO
• Check the motor connection
• The computer USB port does not
work
• The device's drivers are not
installed
• There is hardware conflict with
other devices connected to PC
• The programming card's internal
error
• No connection between the
programming card and TITAN
• Incompatible firmware
• Install the driver (see point 3.2)
• Connect the USB-Link to another
USB port
• Disconnect other devices from
USB ports
• Update the firmware of the
programming card
• Check if the wires are damaged
• Disconnect and reconnect the
TITAN
• Update the programming card's
firmware
• Update the TITAN's firmware
AEG stops firing suddenly. • The internal protection was
activated
• The battery is discharged
• Read the DTC
• Wait a few seconds and try again
After connecting the battery to AEG,
the AEG does not fire. No vibrations.
After connecting the USB-Link to
PC, it is not recognized by GATE
Control Station App.
After connecting the programming
card to TITAN, display's LED
indicators turn on and off every one
second.
The lines of LED indicators on the
programming card turn on and off
one by one.
In case you have any difficulties while using this product, we recommend to email us at
titan@gatee.eu.
To Next Page
Loading...
