26
WWW.GATEE.EU
USER GUIDE
07
2.5 First run
A few initial shots are 'calibration shots'. TITAN adapts to the gearbox configuration. In
order to readapt TITAN, you must restore factory settings. This is necessary e. g. if you
modified gears ratio or replaced motor.
ATTENTION!
Remember! after connecting the device the first time, you should:
•
•
•
download the most updated version of GATE Control Station
make the firmware update
configure the gear type (if your gears are not stock)
If all the sensors work flawlessy, you can assemble the gearbox. Do not use too much
grease. In a critical situation, excessive grease may cover a sensor.
You have successfully installed the drop-in module. Now it's time to configure your TITAN.
Go to the USB-Link chapter (p. 27) or the Tactical Programming Card chapter (p. 39).
To Next Page
Loading...
