Gatekeeper Y35 HD v3 - Step 7: Setting up Authorised Users

Y35 HD v3 User Manual & Install Guide
40 of 156
another 600 seconds (10 Minutes) before
shutting down.
Please change this setting to reflect the
preferred duration of time you wish to continue
recording after the vehicle is turned off.
After that, you need to select the preferred speed measurement unit which will be used by the device.
Navigate to: Main Menu → Setup → Collection → General → Speed
Please verify that the following default settings are correctly configured. For a detailed explanation of
each setting, please see Section 6.5.1.
Speed
Unit
DEFAULT SETTINGS:
▪ MPH
Please set the preferred speed measurement
unit used in your region of operations.
Fleets operating in North America will typically
use MPH. Fleets operating in most other parts
of the world (including Canada) where the
metric system is adopted will typically choose
KM/H.
4.7 Step 7: Setting Up Authorised Users
Next you can add additional user login accounts to the device if required.
Navigate to: Main Menu → Setup → Basic Setup → User Setup
The Y35 HD v3 comes pre-configured with the following two default user accounts:
Default administrator user
▪ Username – admin
▪ Password - admin
Default normal user
▪ Username – user
▪ Password - user