Gatekeeper Y35 HD v3 - Step 4: Setting the Date and Time

Y35 HD v3 User Manual & Install Guide
37 of 156
▪ Alarm – where you will be able to configure recording, snapshot and other actions which the
device will perform when an alarm event occurs. For a detailed explanation, please see Section
6.6.
▪ Maintenance – where you will be able to perform various maintenance actions, including data
export and firmware upgrades. For a detailed explanation, please see Section 6.7.
Each of these major configuration sections have their separate subsections.
For the basic setup process, we will need to verify and/or configure the following settings in the
subsections of the configuration diagram on page 64.
Under the Basic section:
▪ Regist Info options
▪ Time Setup options
▪ Startup options
▪ User Setup options
▪ Network
▪ Application
▪ Other setup
Under the Surveillance section:
▪ Record options
▪ IPC Setup options
4.4 Step 4: Setting the Date and Time
The first step is to ensure that the date and time is set correctly in the device.
Navigate to: Main Menu → Setup → Basic Setup → Time Setup
Please verify that the following default settings are correctly configured. For a detailed explanation of
each setting, please see Section 6.3.2.
General
Date Format
DEFAULT SETTINGS:
▪ MONTH/DAY/YEAR
Time Format
DEFAULT SETTINGS:
▪ 24 Hours
Time Zone
DEFAULT SETTINGS:
▪ (GMT-08:00) PACIFIC TIME (US &
CANADA)
If this is not your time zone, please change this
setting as appropriate to the actual time zone
that your fleet will be operating in.