Gatekeeper Y35 HD v3 - Page 43

Y35 HD v3 User Manual & Install Guide
43 of 156
connected. Please note that the system
will show a video loss message on
channels which are enabled, but do not
have a connected camera (i.e., no
incoming video stream).
Likewise, for channel 5 (Digital IP Camera
channel), only enable this channel if it
actually has a camera connected.
Resolution
DEFAULT SETTINGS:
DVR detects and uses the highest
resolution of the camera for the field. For
example, if a 720p camera is connected,
the resolution should set to 720p, if a
1080p camera is connected the resolution
should set to 1080p.
Frame Rate
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
▪ 15
Quality
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
▪ 1 (Best)
Record Mode
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
▪ Power Up
Audio
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
▪ Checkbox – Selected
Alarm Quality
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
▪ 1 (Best)
Encode Mode
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
▪ CBR
Sub Stream
Channel
DEFAULT SETTINGS:
▪ 1