Step 11 Sure Cuts A Lot is ready to use.
2.6.2.2 Manually Activate Software
If the computer connected to cutter doesn’t have internet connection to accomplish above
software activation process, you can use “Activate manually” function alternatively to enter the
“Activation Code” to start the usage of Sure Cuts A Lot. Meanwhile, you need to find another
computer that has internet access to obtain the “Activation Code” in advance following below
instructions.
Step 1 Check the "Activate manually" checkbox and you should see the Site Code and
Activation Code fields appear. The Site Code field will be pre-filled in and cannot be
changed.
Note
If you use a trial version to output graphics, meaning you do not enter the
two extra lines cut through the design, therefore, make sure the Sure Cuts
A Lot software is activated before implementing cutting jobs.
To Next Page
Loading...
