GCC Technologies LaserPro E200 Series - 10.1 GCC LaserPro E200 Specification sheet

10.1 GCC LaserPro E200 Specification sheet
* Speed does not equal to throughput. See dealer or visit www.GCCworld.com for more details.
*
Specifications are subject to change without prior notice.
* Caution—Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
LaserPro E200
Work Area
20 x 12.9in. (510 x 330mm)
Maximum Part Size
(WxLxH)
20.4 x 13.4 x 0.78in.(520 x 340 x 20 mm) (with grid cutting
table)
19.8 x 13.4 x 2.99in.(505 x 340 x 76 mm) (remove grid
cutting table)
CCD Camera
Standard
Working table
Standard grid cutting table
Dimensions
36 x 30.7 x 11.8 in. (915 x 780 x 300mm)
Laser Source
40W Sealed CO2 Laser
Drive
Closed-loop DC Servo Control
Maximum Working Speed
20 IPS
Maximum Cutting
Thickness
10mm
Speed Control
Adjustable from 0.1~100% (Up to 5 color-linked speed
settings per job
Power Control
Adjustable from 0~100% (Up to 5 color-linked power
settings per job
DPI
Available 250,380,500,760,1000
Focus Lens
Standard 1.5”
Computer interface
Full-speed USB 2.0 port, 10 Base-T Ethernet
Compatible Operating
systems
MS Windows, MAC OSX 10.6-10.15**
Control Panel
7” touch screen
Connection
WiFi, Ethernet, USB
Water Chiller
Standard
Safety
Class I Laser Product Complies with EN60825-1
Class II Laser Product Complies with CDRH
Facility Requirements
Electrical
100-240VAC, 50-60Hz Auto Switching, Max. 15A
Air Exhaust System
External exhaust system with minimum flow rate 300 m3/h
(10594 ft3/h) is required, 2,500PA negative pressure
(PURE-AIR PA-300 @ 4" exhaust port)