GCC Technologies LaserPro E200 Series - File Management Page >> File Edit Vector Page

73
• Raster Power: 0.0% - 100%
• Raster Speed: 0.1% - 100%
7.4.6 File Management Page >> File Edit Vector Page
The File Edit Vector Page allows you to edit the vector pen, vector power, vector speed, and vector PPI, and
power ramp settings for the selected job. These settings correspond to the same settings found on the
LaserPro E200 driver. This page allows you to easily adjust these values to make immediate adjustments
while processing your loaded jobs, even when you have disconnected your computer from the LaserPro E200.
• Vector Pen: 1 - 5
• Vector Power: 0.0% - 100%
• Vector Speed: 0.0% - 100%
• Vector PPI: 30 - 1524
• Power Ramp: YES / NO