58
7.3.2 Color Management
LaserPro driver uses pen color settings to control laser engraver engraving and cutting parameters.
In addition to having your Page Setup and Orientation properly set in your graphics software, you
will also need to make sure Color Management is DISABLED prior to working with the LaserPro
E200 Print Driver
From your graphic software’s Color Management page:
Disable Color Management or set Color Management to Off.
CorelDRA
W
Example
(Color
Management)
The following is an example of how to properly disable Color Management in the graphics software.
CorelDRAW is the designated graphics software used for this example. For other graphics software,
you will need to access the corresponding Color Management page.
1) From the primary menu, click TOOLS
→
COLOR MANAGEMENT and CorelDRAW’s Color
Management will appear.
2) Under the Style pull down menu, select COLOR MANAGEMENT OFF.
3) Click OK to complete the color management adjustments.
To Next Page
Loading...
