Keeping your LaserPro E200 clean and well maintained will ensure quality output, consistent reliability,
and extended product life. Smoke, dust or residue build-up inside the laser system or the mechanical
components can cause a reduction in the laser power, irregularities in the motion system, reduced
product life cycle, and a host of other avoidable problems. This section will cover how to perform
regular maintenance on the LaserPro E200’s worktable, motion system, mirrors, and focal lens.
The frequency of the cleaning schedule will depend on number of variables such as the types of material
you work with, the immediate work environment, the frequency of use, the quality of the exhaust system,
etc. Clean the machine on weekly base for normal case.
WARNING
・ Electrical shock may occur if you do not turn off and unplug the E200 before cleaning.
・ Damage may occur to the system if you do not turn off and unplug the E200
before cleaning.
・
Always turn off and unplug the LaserPro E200 before cleaning!
・ Resulting debris from laser cutting are very dangerous and may cause fire hazard.
9.1 Suggested Cleaning and Maintenance Supplies
Cleaning / Maintenance Tool
Soap Solution or All-Purpose Cleaner
DO NOT use alcohol on any painted surface, plastic,
or the laser system!
ONLY to be used on the working table
Vacuum Cleaner with a Flexible Nozzle
Only to be used in and around the worktable and
motion system
1pc Supplied; suggest source locally*
To Next Page
Loading...
