Cassette and tray identification
When the door of the fraction collector is closed automatic scanning is performed. There
are two types of scanning procedures:
•
Full scan: Scanning of cassette type codes to determine which types of cassettes
are used, and scanning of rows and columns in deep well plates to identify which
types of plates are used (24, 48, or 96 wells). Full scan is performed only when the
system is in state Ready.
•
Quick scan: Scanning of cassette type codes to determine which type of cassettes
are used. Quick scan is performed during the run to ensure that correct cassettes
are placed in the fraction collector.
WARNING
Moving parts in fraction collector. Do not open the fraction collec-
tor drawer when the fraction collector is active. If you need to ac-
cess the fraction collector, press Pause, and make sure that the
movement has stopped before opening the drawer.
View fraction collector content
To view the content of the Fraction collector, open the System control module. On the
View menu, click Fraction Collector Content.
ÄKTA avant Operating Instructions 29101556 AB 127
5 Prepare the system for a run
5.7 Prepare the built-in fraction collector
To Next Page
Loading...
