GE AKTA avant - Prime Inlets and Purge Pump Heads

4.5 Prime inlets and purge pump heads
About this section
Before using the sample pump or system pumps it is important to do the following:
•
Prime the inlets (fill the inlets with liquid).
•
Purge the pumps (remove air from the pump heads).
This section describes how to prime the buffer inlets, sample inlets, and Q inlets, and
how to purge the system pumps and the sample pump.
In this section
This section contains the following subsections:
See pageSection
864.5.1 Prime buffer inlets and purge system pumps
934.5.2 Prime sample inlets and purge Sample Pump
984.5.3 Prime Q inlets
ÄKTA avant Operating Instructions 29101556 AB 85
4 Installation
4.5 Prime inlets and purge pump heads