To Next Page

To Previous Page

4.1.6 Required materials

Introduction

This section describes the accessories required for the installation and operation of the

ÄKTA avant instrument.

Buffers and solutions

The buffers and solutions listed in the following table are required during the installation

procedure and should be provided at the installation site.

Scope of useRequired volumeBuffer/solution

Air sensor test, fraction collector

test, Quaternary Valve test and

system test

1 literDistilled water

Quaternary Valve test0.5 liter1% acetone in distilled

water

System test0.5 liter1% acetone and 1 M NaCl

in distilled water

Priming of the pump piston rinsing

system

200 ml20% ethanol

Laboratory equipment

The equipment listed in the following table is required during the installation procedure

and should be provided at the installation site.

SpecificationEquipment

For buffers and wasteFlasks, liquid containers

For protectionGloves

For protectionProtective glasses

ÄKTA avant Operating Instructions 29101556 AB 63

4 Installation

4.1 Site preparation

4.1.6 Required materials

GE AKTA avant Operating Instructions

Other manuals for GE AKTA avant