GE AKTA avant - Hardware Installation

4.2 Hardware installation
About this section
This section describes the installation procedure of an ÄKTA avant system.
For information on how to how to unpack the ÄKTA avant instrument and how
to lift the instrument onto a laboratory bench see ÄKTA avant Unpacking In-
structions.
Note:
WARNING
Protective ground. The product must always be connected to a
grounded power outlet.
WARNING
Power cord. Only use power cords with approved plugs delivered
or approved by GE.
WARNING
Access to power switch and power cord with plug. Do not block
access to the power switch and power cord. The power switch
must always be easy to access. The power cord with plug must
always be easy to disconnect.
In this section
See pageSection
684.2.1 Install the computer equipment
694.2.2 Connect the system units
734.2.3 Prepare waste tubing
764.2.4 Install the Barcode Scanner 2-D and the pH electrode
774.2.5 Prepare the pump rinsing system
66 ÄKTA avant Operating Instructions 29101556 AB
4 Installation
4.2 Hardware installation