ActionStep
Unscrew the two white plastic screws located below each pump head by
hand. Pull the plastic connectors to the sides to release the inlet manifold.
3
Disconnect the tubing of the pump piston rinsing system.4
Unscrew the two screws of the front section of the pump head using a star
screwdriver T20, and pull off the front section.
5
ÄKTA avant Operating Instructions 29101556 AB 155
7 Maintenance
7.2 Replace pump piston seal, O-rings, and rinse membrane of Pump P9 or Pump P9H
To Next Page
Loading...
