APPENDIX D: USING CONFIGPRO WITH D20MX
D20MX INSTRUCTION MANUAL GE INFORMATION 129
5.4.5. Right-click the device and generate all the tables of the device. Carefully
review and resolve all error and warnings.
Note: A red dot on a device indicates that the device's tables need to be
generated. Unresolved errors makes the red dot remains
5.4.6. Open up the device and go to the Wesmaint II+ application to compare
the RADIUS Role [RADR] tables in the factory default D20MX device with
that in the newly modified D20MX device. Compare the first two columns
[Role ID and Role Name] as shown below to confirm the import was
successful. If not, repeat the import process.
6. Generate the device configuration, after a configuration has been properly
configured.
Result: If there are no errors or warnings, the red dot on the device should not appear
and the generated device is ready to be downloaded into the D20MX RTU.
7. The transfer of a D20 configuration into a D20MX configuration is complete.
To Next Page
Loading...
